خيارات الإقلاع في الوندوز7 عند الضغط على f8

خيارات الإقلاع في الوندوز7 عند الضغط على F8







Advanced Option


Repair Your Computer
Shows a list of system recovery tools you can use to repair startup problems, run diagnostics, or restore your system. This option is usually only available if the tools are installed on your computer's hard disk. For example, when you only have a OEM recovery partition instead of a Windows 7 installation disc. If you have a Windows 7 installation disc, the System Recovery Options are located on the installation disc.

Safe Mode
This starts Windows 7 with a minimal set of drivers and services.

Safe Mode with Networking
This starts Windows 7 in safe mode and includes the network drivers and services needed to access the Internet or other computers on your network.

Safe Mode with Command Prompt
This starts Windows 7 in safe mode with a command prompt window instead of the usual Windows interface. To exit from here, press Ctrl+Alt+Delete or type Exit and press Enter.

Enable Boot Logging
Creates a file ****d ntbtlog.txt, that lists all the drivers that are installed during startup and that might be useful for advanced troubleshooting.

Enable Low Resolution Video (640 X 480)
Starts Windows 7 using your current video driver and using low resolution and ******* rate settings. You can use this mode to reset your display settings, or to use a television monitor with your computer if needed.

Last Know Good Configuration (advanced)
Starts Windows 7 with the most recent registry and driver configurations that worked successfully. Every time you turn your computer off and Windows 7 shuts down successfully, important system settings are saved in the registry. You can use those settings to start your computer if a problem occurs. For example, if a new driver for your video card is causing problems, or an incorrect registry setting is preventing Windows 7 from starting correctly, you can restart your computer using Last Known Good Configuration.

Directory Services Restore Mode
Starts Windows 7 domain controller running Active Directory so that the directory service can be restored. This option is intended for IT professionals and administrators.

Debugging Mode
Starts Windows 7 in an advanced troubleshooting mode intended for IT professionals and system administrators.

Disable Automatic Restart on System Failure
Prevents Windows 7 from automatically restarting if an error causes Vista to fail. Choose this option only if Vista is stuck in a loop where Vista fails, attempts to restart, and fails again repeatedly.

Disable Driver Signature Enforcement
Allows drivers containing improper signatures to be temporarily installed.

Start Windows Normally
Starts Windows 7 in its normal mode to the logon screen or user desktop. This can be helpful after a improper shutdown.



أخوكم:


إرشيد الجرايدة
المفرق-الأردن